Minimum Order Quantity: 1 Piece
|Induced Draft Type
|Installation/After Sales Service Required
|Gold Cooling Tower
Gold Cooling Towers is a young and dynamic and leading company in the field of manufacturing New FRP Cooling towers over the past 12 years with full-fledged mfg. capacity upto 1500TR, offering single source responsibility for complete water-cooling solutions to industry.Introduction – DRY COOLING TOWERS (Remote Radiate)
Now, taking more responsibility for manufacturing customer’s most required Water savage, lowest annual cost and lowest noise level towers like DRY COOLING TOWERS.
DRY COOLING TOWERS are in a single unit can be provided incapacities
from 100KW to 1500KW and they can be multiplexed to reach many thousands of KILOWATTS.
A Dry Cooling Towers?
The Dry Cooling Tower consists of Air Cooled fluid coolers, water is passed through the fluid coolers and atmospheric air is forced through the external fluid coolers. The heat from the water is transferred to the cooling air and the water is cooled.
Why Dry Cooling Towers?
SAY “YES” TO ALL “NOS” BELOW.
NO contamination of air
NO frequent maintenance
NO WATER requires after first.
NO Moving parts except Fan & Motor.
NO Mixing of Dust/Dirt/Fly Ash with water
NO need of water softening plant & Chemicals.
NO Heat Exchanger Headaches at Primary Circuit
The Dry Cooling Towers water line connections are flanged for quick installation and it can be used for the following major applications
1. POWER GENETAIONS / GENSETS
2. AIR COMPRESSOR COOLING / AFTER COOLER / INTER COOLER/ JACKET
Air-Cooled Fluid Coolers
Air-Cooled fluid coolers are being produced in our most modern plant of International standards. The design, selection, construction of air-cooled fluid coolers are through computer which gives very accurate thermal transfer. The Tubes and fins can be Copper, Aluminum.
Axial flow fans are directly driven by motor. The fans are of aluminum die cast with adjustable pitch and are individually tested for different flow rate. They are all dynamically balanced. Since, the complete fan is of aluminum alloy it does not corrode when used in outdoor application.
The motors are IP 55 Class with F class insulation and low rpm of the motor minimize noises and increases efficiency. Motors are specially designed to take the moisture / rain, dust and to withstand atmospheric temp. up-to 120oC.
Mild steel sheets of heavy gauge steel are used for enclosure construction. The units are powder coated with 80 microns
The entire unit is assembled on heavy duty channel base frame and it can be placed in open ground or can be mounted on roof top depending upon the job site requirements. The structures are rigid and are painted suitably to give protection against corrosion.
View Complete details